5/8" Stud Kit with .875" Wide Shank Includes Lug Nuts & .438" Thick Washers For Strange Two Piece Pro Stock Axles
1 × $100.00
Side Bearing Kit For OEM Dana 60
1 × $69.00
Ford 9" 4.11 Pro Gear with 35 Spline Pinion Motive Performance Gear - Produced in Italy
1 × $700.00
Strange Pro Carbon Rear Brake Kit For 4 3/4" & 5" Bolt Circles Fits 2012 and Earlier Strange Floater Kits
1 × $3,295.00
Subtotal: $4,164.00
$275.00
Application
New Ford 9″ housing orders
Description
Option to add a back brace
Note
Any obstacles will cause brace to terminate before tube end
• Significantly increase rigidity of housing
• Minimizes tube flex
• Protects axle shafts & bearings from bending loads
• May also improve ring and pinion life
The extra strength a back brace offers is highly recommended if you have a ford 9 inch rear end on a heavy car that has more than 800 horsepower and sporting a big tire setup.
This heavy-duty steel option provides the maximum in your 9in rear end’s structural rigidity with minimal addition to weight. It gives your rear end the extra reinforcement needed to help prevent bending and flexing of the housing and tubes that can occur under the most punishing conditions.
