Strange 12 Bolt Casting Plug
1 × $16.50
Side Bearing Kit For OEM Dana 60
1 × $69.00
Dragster Rear Plumbing Kit With 3 AN Braided Stainless Steel Lines & Fittings
1 × $95.00
Rear Pinion Race For OEM Dana 60 & Strange S60
1 × $16.00
Subtotal: $196.50
$275.00
Application
New Ford 9″ housing orders
Description
Option to add a back brace
Note
Any obstacles will cause brace to terminate before tube end
• Significantly increase rigidity of housing
• Minimizes tube flex
• Protects axle shafts & bearings from bending loads
• May also improve ring and pinion life
The extra strength a back brace offers is highly recommended if you have a ford 9 inch rear end on a heavy car that has more than 800 horsepower and sporting a big tire setup.
This heavy-duty steel option provides the maximum in your 9in rear end’s structural rigidity with minimal addition to weight. It gives your rear end the extra reinforcement needed to help prevent bending and flexing of the housing and tubes that can occur under the most punishing conditions.
