Pro II Stainless Steel Dual Rear Brake Kit For 3.150″ Symmetrical Housing Ends 2 Pc Rotors, 4 Piston Calipers & DRM-35 Metallic Pads

 
Designed Specifically For Drag Racing

Application
Symmetrical 3.150″ housing ends

Requires
• H1131 housing ends or equivalent
• 2.832″ brake offset
• Ball style axle bearings *

* Caliper mount relief isn’t correct for tapered bearings

For Symmetrical 3.350″ ends – B1711WCDM2S

Two Piece Stainless Steel Rotors – B2794LS / B2794RS
• Internal cogs allow rotor to float
• Allows for expansion variances between aluminum & steel
• Slots reduce rotating weight and increase air flow
• Stainless steel maintains stability under higher temperatures

Four Piston Billet Aluminum Calipers
• Billet stainless steel pistons greatly reduce deflection
• All pistons are 1.750″ providing increased clamping force
• Remains ridged under high pressures
• Choice of black or red calipers

Aluminum Dual Caliper Mounts
• Billet one piece design
• Eliminates bolts, spacers & nuts that require periodic maintenance

DRM-35 Metallic Brake Pads
• Provides high resistance to brake fade
• Recommended for vehicles going over 150 MPH in the 1/4 mile
• Maintains decent starting-line cold holding capabilities
• May leave pad residue on rotors when not using parachute
• While common, it’s recommended to remove when installing new pads

Housing End Bolt Kit
• Additional components not supplied in most aftermarket brake kits

Brake Hoses and Lines are not Included
Calipers are tapped 1/8″ NPT and supplied with male 3 AN fittings