Pinion Seal Kit For OEM Dana 60 & Strange S60
1 × $12.00
Pinion Support Bearing Kit For OEM Ford Support (Non-Daytona)
2 × $80.00
Strange Billet 4 Piston Caliper Kit - Red With DRM-40 Metallic Pads
1 × $489.00
Pinion Support Bearing Kit For Use With 35 Spline Pinion Shaft
1 × $105.00
Side Bearing Kit GM 12 Bolt and Ford 8.8"
1 × $45.00
9" Ford Housing Center For Use With 3" OD Tubing
1 × $325.00
Subtotal: $1,136.00
$275.00
Application
New Ford 9″ housing orders
Description
Option to add a back brace
Note
Any obstacles will cause brace to terminate before tube end
• Significantly increase rigidity of housing
• Minimizes tube flex
• Protects axle shafts & bearings from bending loads
• May also improve ring and pinion life
The extra strength a back brace offers is highly recommended if you have a ford 9 inch rear end on a heavy car that has more than 800 horsepower and sporting a big tire setup.
This heavy-duty steel option provides the maximum in your 9in rear end’s structural rigidity with minimal addition to weight. It gives your rear end the extra reinforcement needed to help prevent bending and flexing of the housing and tubes that can occur under the most punishing conditions.
Pinion Seal Kit For OEM Dana 60 & Strange S60
1 × $12.00
Pinion Support Bearing Kit For OEM Ford Support (Non-Daytona)
2 × $80.00
Strange Billet 4 Piston Caliper Kit - Red With DRM-40 Metallic Pads
1 × $489.00
Pinion Support Bearing Kit For Use With 35 Spline Pinion Shaft
1 × $105.00
Side Bearing Kit GM 12 Bolt and Ford 8.8"
1 × $45.00
9" Ford Housing Center For Use With 3" OD Tubing
1 × $325.00
